Categories

How Processing Affects the Wear Resistance of SiC Ceramic Composites

A study on SiC/NbC ceramic composites shows how processing affects wear resistance, with one sample achieving a nearly 88% lower specific wear rate under a 20 N test load.
Nov 7th,2026 74 Views

How Processing Affects the Wear Resistance of SiC Ceramic Composites

A study in the Journal of the European Ceramic Society compares how two processing routes affect silicon carbide–niobium carbide (SiC/NbC) ceramic composites. The findings show that differences in microstructure can significantly influence friction and wear performance.

Comparing Two Processing Routes

The researchers used spark plasma sintering (SPS) to produce the composites through two approaches. One involved conventional powder consolidation. The other used partially reactive processing, in which some silicon carbide formed in situ during preparation.

Niobium carbide was introduced as a secondary phase at concentrations of 5, 10 and 20 wt.%. The team then investigated the phase composition, microstructure, mechanical properties and tribological behaviour of the resulting materials.

Nearly 88% Lower Specific Wear Rate Under Defined Test Conditions

Under a 20 N load, the reactively processed composite containing 20 wt.% NbC exhibited a specific wear rate nearly 88% lower than its conventionally processed counterpart.

Specific wear rate measures the volume of material lost per unit load and sliding distance. The reported reduction applies to this particular sample comparison and its test conditions.

The researchers associated the improvement with lower residual porosity and reduced brittle material removal during wear. Partially reactive processing also promoted better densification, improved fracture resistance and greater tribological stability.

Looking Beyond Material Composition

The study shows that even at the same NbC concentration, different processing routes can produce internal structures with different wear characteristics.

For ceramic component development, the relationship between composition, densification, residual porosity and material removal deserves attention alongside measured performance. These findings provide experimental support for using partially reactive SPS processing to tailor the properties of SiC-based ceramic composites.

Implications for Industrial Wear Components

From an engineering perspective, the study encourages consideration of processing and microstructure alongside material composition when evaluating candidates for pump components, mechanical seals and other wear-resistant parts.

Applying laboratory findings to a working component requires testing that reflects its operating conditions. The mating material, load, sliding speed, process medium and lubrication conditions should all form part of that assessment.

Application-specific testing can help establish whether a candidate material meets the equipment’s requirements.


Source and Editorial Note

Prepared by CERAMPRO based on the publicly available abstract of the following research paper. The discussion of industrial applications is editorial commentary.

Richard Sedlák et al.
Mechanical and tribological performance of SiC/NbC ceramic composites fabricated by conventional and reactive processing
Journal of the European Ceramic Society
Article 118950
DOI 10.1016/j.jeurceramsoc.2026.118950

Read the original paper

Leave a message
Name *
Email *
Phone *
Message *
We use Cookie to improve your online experience. By continuing browsing this website, we assume you agree our use of Cookie.